Butts of Bawtry TBT2519, Инструкция по эксплуатации, Страница: 13 / 20

6/ Properly set the bit holder.
7/ The bit can become very hot during
operation exercise extreme caution as this
could cause injury.
8/ Always wear protective safety glasses
9/ Always wear ear defenders or ear plugs
10/ Always wear suitable dust mask
11/ Always wear protective foot wear.
12/ Always wear hard hat
Information on how to use the SDS drill.
Prior to operation
1. Power source
Ensure that the power source to be
utilized conforms to the power requirements
specified on the product nameplate.
2. Grounding
This tool should be grounded while in use
to protect the operator from electric shock.
The tool is equipped with a three conductor
cord and grounding type receptacle, The
green (or green and yellow)conductor in the
cord is the grounding wire. Never connect the
green (or green and yellow) wire to a live or
neutral terminal.
3. Power switch
Ensure that the power switch is in the off
position. If the plug is connected to a power
receptacle while the power switch is in the on
position, the power tool will start operating
immediately . inviting serious injury.
4. Extension cord.
When the work area is away from the
power source, use an extension cord of
sufficient thickness and rated capacity. The
extension cord should be kept as short as
practicable
Fig 1 – 1
25mm
1/ Raise the retainer and insert the shank
portion of a drill bit into the hexagonal hole on
the front cover until it reaches the extremity.
2/ By slightly tapping the top of the bit holder
with a wooden mallet, replace the bit holder
to grip the bit firmly.
Fig 1 - 2
38mm
1/ Pushing the stopper to arrow A direction,
turning the retainer to arrow B direction. After,
insert the tool shank into the hexagon hole on
the front cover.
2/ Pushing the stopper to arrow A direction
turning the retainer to arrow B in the opposite
direction. After, apart the stopper.
Note:
When dismounting the bull points
reverse the procedures described above.
How to use the hammer drill.
How to drill holes
(1) Pull the switch trigger after applying the
drill bit tip to the drilling position.
(2) It is unnecessary to forcibly press the drill
main body to the work area. It is sufficient to
slightly press the drill to an extent that chips
are freely discharged.
CAUTION
Although a safety clutch is built in this drill,
the drill can be suddenly halted when it
strikes against a buried reinforcing bar or
stone, and the drill starts a reverse operation
as a reaction and can kick back.
Always continue a hole-drilling job while
strongly gripping both the side handle and
the main handle.
How to clip or crunch.
By applying the drill bit tip to the chipping or
crushing position, operate the drill by utilizing
its own weight.
Forcible pressing or thrusting is unnecessary
and will wear the drill and bits, this could
shorten then life of the drill and bits.
ALL ACCESSORIES CAN BE
PURCHASED FROM YOUR LOCAL TOOL
DEALER or HIRE SHOP.
ASSEMBLY & OPERATION
14