Attach the ButtKicker Gamer
to your center post chair
1.
Raise the pneumatic lift on your chair (make the seat of the chair
higher). Then, push down the sleeve covering the center post to
expose the post. (refer to figure 1)
2.
Loosen the knob on the arm of the ButtKicker Gamer and place
the clamp around the post.
3.
Tighten the knob and secure the ButtKicker Gamer in place on
the chair seat. (refer to figure 1)
4.
Use the supplied Velcro® cable wraps to tie the end of the
ButtKicker Gamer cable to one leg of your seat. (refer to figure 2)
Position the ButtKicker Power Amplifier and
connect to the ButtKicker Gamer
Do not turn on the amplifier until all
of the connections are made!
1.
Connect the long quick release cable to the short cable coming
from the ButtKicker Gamer. (refer to large diagram &
figure 2b
)
[Note that the cables may be disconnected using the quick release
connector at any time if desired.
HOWEVER
,
make sure the
amplifier is turned OFF
BEFORE
disconnecting the cables.]
2.
Connect the long quick release cable to the banana jacks on the
back of the ButtKicker Gamer Amplifier. (+) connects to the red
terminal, (-) connects to the black terminal.
3.
Position the amplifier near the audio source and accessible
to the user
.
4.
If desired, plug the included wired ButtKicker Remote into the
serial port on the front of the ButtKicker Power Amplifier.
5.
Connect the power cord to the power terminal on the back of the
ButtKicker Power Amplifier and then plug it into a power outlet.
Connecting the audio signal from the gaming
console to the ButtKicer Power Amplifier
For a gaming console hooked up to a separate surround sound
system,
use the RCA “Y” adaptor to split the “sub out” output of your
surround sound processor. Use the 5’ RCA to RCA cable to connect one
leg of the RCA “Y” adaptor to the “line level input” RCA input (White) on
the back of the ButtKicker Power Amplifier, and connect the audio cable
of your subwoofer to the other leg of the RCA “Y” adaptor.
For a gaming console setup without a separate sound system
, using
an Optical to Analog RCA Converter (sold separately) connect the Optical
Output (TOSLINK) port of the console to the Optical Input of the Optical to
Analog RCA Converter. Connect either the Left or Right RCA Output of
the Converter to the Input of the ButtKicker Power Amplifier. For
wireless headphones with a base station with an optical output use the
same connection method as above. See the diagram on the next page
for connection details.
Optionally, you can connect directly a console controller/console 3.5mm
(headphone) output using the 3.5mm Y splitter to allow for connection to
wired headphones and the ButtKicker Gamer amplifier.
CONSOLE GAMING
START HERE
PLEASE NOTE:
THE QUICK CONNECT CABLE ONLY FITS ONE WAY.
Make sure pins are properly aligned with the large pin
in the large hole and the small pin in the small hole.
Figure 1
Figure 2
Figure 2b
