Butler TUBE DRIVER BLUE, Информация владельца

Страница: 6 / 17

4
Tools Needed for Typical Installation (not supplied)
•
Phillips screwdriver (#2 or medium sized)
•
Wire cutters
•
Wire strippers
•
Mounting / Ground connection screws
•
Ring connectors (Large enough to accommodate your method
of grounding and power connection)
•
Speaker wire – 16 gauge or larger
•
Connector crimper tool
•
Grommets (sized to work with the power wore you plan to use
in your installation
•
Tube of silicon Sealant
Current Supply
The information below is a basic formula you can use to
determine approximate maximum current draw. A 50% amplifier
efficiency rating is used as an average. This formula is only a
guideline. Using wire of a larger gauge improves the current
transfer of your system, so if in doubt, always use larger cables.
Do NOT use smaller gauge wire.
Total 4-Ohm rated RMS output x 5 = Total Input Wattage
Total Input Wattage/Supply Voltage = Current Draw (in Amps)
Example: Your TD BLUE has 5 channels at 75 watts per channel
RMS into 4-Ohms (75 x 5 = 375W). You would use the formula
below:
375W x 5 = 750W/12.5V = 60 Amps Total Current Draw
The chart on the next page will help you to determine the gauge of
power / ground cables necessary for proper operation of your
Tube Driver.