INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 26 of 98
TOOL EXTRACTION
THE FOLLOWING OPERATIONS
MUST BE CARRIED OUT WITH
THE TOOLS HEAD IN “OFF- WORK”
POSITION.
1) Push the lever (
Fig. 24 ref. 1
) towards the tool arm
and place the head (
Fig. 24 ref. 2
) at 90° compared
to the work position.
2) Lift the head manually until the pin fits automati-
cally.
3) Now the head (
Fig. 25 ref. 1
) stays up, allowing
easily the rotation operations described before.
90°
1
2
Fig. 24
1
Fig. 25
TOOL INTRODUCTION
1) Push the lever (
Fig. 26 ref. 1
) towards the tool arm
and place the head (
Fig. 26 ref. 2
) at 90° compared
to the work position.
2) Lower the head (
Fig. 27 ref. 1
) manually, until the
locking pin fits automatically.
DURING THIS OPERATION, WITH
THE HAND LEFT FREE, MOVE THE
HEAD (FIG. 27 REF. 1) DOWN-
WARDS.
3) At this point, it is possible to rotate the head (
Fig. 27
ref. 1
) as described before.
PAY ATTENTION NOT TO SQUASH
THE HANDS BETWEEN THE TOOL
SUPPORT AND THE ARM!
90°
1
2
Fig. 26
1
Fig. 27
7505-M002-4_B
NAV41.11N - NAV41T.11N - NAV41.13N - NAV41T.13N -
NAV41.13EI - NAV41T.13EI - NAV41.13SA - NAV41T.13SA
