BUTCHER BOY TCA32 COUNTER TOP GRINDER
PAGE 1
Before installing, operating or cleaning the BUTCHER BOY TCA32 GRINDER all
persons coming into contact with this equipment must read and completely
understand the contents of this document.
If you have any doubts about the installation, operation or cleaning of this equipment
contact the dealer from which the equipment was purchased or contact the factory.
BUTCHER BOY TCA32 GRINDERS
are manufactured solely to cut meat, chicken and fish.
The grinders are not intended for other purposes.
UPON RECEIPT OF THE GRINDER: Thoroughly inspect the grinder for any damage that
may have occurred during transit. If damage is detected contact the carrier for instructions.
A. INSTALLATION:
Unpack and place the grinder on a stable flat surface at a convenient height to the
operator. Make sure the grinder is configured as ordered.
.
On three phase machines
a cord is provided for the electrician to attach the correct plug. On
three phase motors be sure of correct rotation.
Electrical connections must be made by a
qualified electrician and comply with all codes.
SAFETY FEATURES:
BOWL GUARD: Stays with the bowl when the pan is removed.
MEAT STOMPER: Included, used to push meat into bowl through guard.
B. TO REMOVE THE PAN FROM BOWL:
LOCKOUT THE ELECTRICAL POWER!
Loosen thumbscrew and lift pan over guard while moving pan toward rear of machine.
C. TO REMOVE BOWL FROM MACHINE:
LOCKOUT THE ELECTRICAL POWER!
Remove knife and plate ring, pull out feed screw. Rotate lock handle toward front of
bowl to approximately the 12:00 o’clock position. Pull bowl from gearbox (you may need to
wiggle the lock handle slightly). Reverse the removal procedure to reassemble.
Thumbscrew
Lock handle