BUSKRO BK730-2, Руководство пользователя

Страница: 43 / 157

Chapter 3 Mechanical Adjustments Page 3-2
Note : The product must trigger either one of the two product sensors at the front or rear
of the base to enable tab dispensation.
Ensure that the correct product sensor (front or back) has been selected in the
head controller to permit correct operation of the Tabber/Labeler (Section 4.2.1).
3.1.2 Peel Point Setup for Different Product Thickness
The peel point assembly needs to be adjusted whenever the product’s thickness changes
between jobs. The Labeler can handle material up to 1½” thick material.
In order to make adjustments for different product thicknesses:
1. Loosen the Peel Point Up/Down Position Lock Handle.
2. Pull the peel point and the suspension roller up approximately 4 mm from the top
of the mail piece as shown in
Figure 3-2
below.
3. Pull the mail piece in the direction shown to make sure that the mail piece is
snuggly held between the suspension roller and the tabletop belt.
4. Lock the Peel Point Handle into position once the adjustment is made.
Buskro Ltd. BK730-2 Tabber