_
12
_
Maintenance
Gearcase
Maintenance Interval
The gearcase should be checked for lubrication after each 30
hours of use.
Gearcase Lubrication
Remove the cutting attachment and the boss adapter. Clean any
dirt and debris from the area between the boss adapter and the
gearcase. Remove the grease plug from the side of the gearcase.
While rotating the attaching shaft, inject lithium-base bearing
lube (P/N 211337) through the plug hole until the gearcase is full.
Reinstall the boss adapter and grease plug.
Bearing Lube
(P/N.211337)
Grease Plug
Plug Hole
Attaching Shaft
Boss Adapter
Gearcase
General Cleaning and Tightening
The BUSHRANGER Multi-Cutter will provide maximum performance for many, many hours if it is main-
tained properly. Good maintenance includes regular checking of all fasteners for correct tightness, and
cleaning the entire machine.
WARNING
POTENTIAL HAZARD
・
When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・
Contact with moving tool or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・
Always turn off your Multi-Cutter before you clean or perform any maintenance on it.
Storage
Please see your Multi-Cutter Power Unit Owner’s/Operator’s Manual.
1. Perform all regular maintenance procedures and any repairs.
2. Store the Multi-cutter in a dry place away from excessive heat, sparks or open flame.
Troubleshooting
Problem
Cause
Action
Engine will not start
・
STOP switch set to off position
・
Empty fuel tank
・
Primer bulb wasn’t pushed enough
・
Engine flooded
・
Move switch to on position
・
Fill fuel tank
・
Press primer bulb until fuel flows
through the fuel return line
・
Use warm engine starting procedure
Engine will not Idle
・
Idle speed set incorrectly
・
Set Idle speed
Engine lacks power or stalls
when cutting
・
Throttle wire has come loose
・
Dirty air filter
・
Tighten throttle wire
・
Clean or replace air filter
If further assistance is required, contact your local authorized BUSHRANGER service dealer.
Содержание MC-S-2
Страница 15: ......
Страница 16: ...P N 242010 01 GB 1909 IN 11 Sodium Street Narangba Qld 4504 ...