![background image](http://html.mh-extra.com/html/bushranger/dv-12th/dv-12th_manual_2835628005.webp)
Page 4
NOTE:
This product is a very powerful machine. Treat with extreme
care and observe all caution and warnings (See ‘Warnings’ on Page 3 of this
manual).
Before use, ensure that you are familiar with all
winching operations (winch speeds & direction).
In some cases, the operator of a winch may be
required to have qualifications according to applicable
laws and ordinances.
Check all safety and environmental conditions
prior to and during use.
Only use correctly rated rope. Inspect for damage
and/or defects before use.
Do not use an unsuitable hook or snatch block for
rope.
The operator must remain with the winch during
operation.
The winch duty rating is S3 (intermittent-periodic).
Do not use the winch as a lifting device or a hoist for
vertical lifting and moving people.
Ensure that the winch is connected to the correct
voltage (12VDC only).
Do not exceed the maximum line pull ratings shown in
this manual. Shock loads must not exceed these
ratings.
Pull from an angle below 15° in the horizontal plane
to straighten up the vehicle or load.
Always use leather gloves when handling the wire
rope.
When winching, always use a recovery damper. Place
over the rope in the middle third of its length.
A rope should be replaced if it shows signs of
excessive wear, broken strands, corrosion for wire
rope and excessive abrasion or fused and melted fibre
for synthetic rope or any other defects.
If the winch fails to pull a load under normal
conditions, manually stop the operation,
otherwise motor damage may occur. The thermal
indicator LED in the remote will indicate red as a
warning.
Check that
the clutch T-handle is in the “Engaged”
position during and after use.
Safety
Содержание DV-12TH
