2.
Disconnect the start battery by removing the negative terminal. Ensure
ALL accessories, lights and any other powered equipment is off and
“temporary” power is fed into the vehicle via a “memory minder” or
alternate battery.
3.
Select a location for the Voltage Sensitive Relay that is easily accessible
and will not have the cables running near exhausts or turbochargers and
is preferably close to the start battery.
4.
Layout cable from main battery via the VSR position to the location of
the main battery.
5.
Where the cable meets the position of the VSR carefully cut through the
outer sheath of the cable exposing the positive (red) and negative
(black) cable inside.
6.
Cut through the outer sheath exposing approximately 15cm of cable
(remove outer sheath)
7.
Cut through positive (red) cable at the centre of the splice.
8.
Remove from each end of the cable approximately 1cm of outer coating.
9.
Using a set of pliers crimp onto each end supplied cable lugs.
10.
Connect the red positive cable from the battery to the VSR (red marking
on post).
11.
Connect the other lugged cable to the other post on the VSR, twist cable
so both positive and negative wires pass through the housing of the VSR.
12.
Using supplied screws attach VSR to vehicle.
13.
Connect the earth” wire (small black wire) to a suitable earth on the
vehicle.
