Bushnell Back Track GPS HuntTrack 360500, Инструкция по эксплуатации

Страница: 5 / 76

5
BaSic SeTuP
• Open battery cover and insert 3 AAA batteries
(Fig 1,
pg 4)
. Record the serial # inside-you’ll need it later to
register your HuntTrack online. Close the cover.
• Go outdoors. HOLD POWER (1) (keep the button
pressed) until the display comes on. Wait for GPS
satellite lock (icon stops blinking) (11). This may take
a few minutes after the first power-up in a new area.
• Press
SETUP
(4). Press
MARK
(2), then press the
TRIP
(3) or
SETUP
button to set the Hour for your area
(Fig. 2)
. Press the
MARK
button to return to the Setup
screen.
• To change the time and temp/distance formats, press
SETUP to select “12h” or “
0
F/yd”, then press MARK to
set to “24h” or “
0
C/m”. (Fig. 3) . The arrow’s function is
explained on page 6 . Press POWER to exit Setup.
MaRkinG/ReTuRninG to a LocaTion
• Press
POWER
to select one of five Location icons/
or 5-20 numbers (6) (Tent, Truck, Tree, Treestand,
Deer, #1-20). While standing at the Location you
want to mark, HOLD
MARK to save its position in
the HuntTrack’s memory (the display will change
as shown)
(Fig. 4) . You can now turn the power off
(HOLD
POWER
) and leave the location.
• To return to the location you marked, turn the
HuntTrack on. Make sure the same icon or # you used
to mark the location is shown (if not, press
POWER
to select it). The display indicates the direction and
distance back to the location
(Fig. 5) . Move in the
direction of the arrow, watching for the distance to
decrease. When you reach the location, the “Mark”
icon will flash in the center of the display.
Fig. 2
Fig. 4
Fig. 5
Fig. 3