10
Fig. 3: SETUP Information Screen (119936C/119938C)
USING THE SETUP MENU TO CHANGE SETTINGS
The main purpose of the
SETUP
mode is to allow you to change the settings of the camera’s parameters
(
available parameters vary with use of Presets-see pg. 18 for more details
) so your
Core Trail Camera
operates exactly the way you want it to. You will do this by entering the
SETUP
Menu and pressing the
keys beside the LCD display, which will show you each parameter and its setting.
Changing Parameter Settings in SETUP Mode
A wide range of options or “parameters” are provided to allow you to set the
Core Trail Camera
to your
operational preferences. To change the setting of any parameter you must first switch to the
SETUP
mode. Once in
SETUP
mode, pressing the
MENU
button will allow you to select any parameter and
change its setting. The name of the parameter and its current setting will be shown on the LCD.
Pressing the
RIGHT
or
LEFT
key scrolls to the next or previous parameter (
RIGHT
key to move on to the
next parameter and
LEFT
key to go back to the previous parameter), and pressing the
UP
or
DOWN
key
lets you select a different setting for the currently displayed parameter. Once you have selected your
preferred new setting for a parameter, press the
ENTER
button to save the new setting (actually change
it). When you are finished changing the settings of one or more parameters, press
MENU
again to exit
the
SETUP
menu.
MENU
can also be pressed anytime you want to cancel changing a parameter’s setting
after a new setting has been selected (but OK has not been pressed yet). After setting the parameters to
your preferences, be sure to move the switch to
ON
to begin actually taking photos or videos. No images
will be captured if the switch is left in the
SETUP
position
(unless you press the
RIGHT
/Shot key after
exiting the menu)
-in fact, the camera will power off automatically after a few minutes with no key
pressed.
Parameter Settings Display
The settings for each parameter are shown on the display screen of your
Core Trail Camera
. Only one
setting is displayed at a time, starting with the current setting for the parameter when it is first selected
(
pg. 13, Fig. 4a
). To change the setting, use the UP/DOWN keys to display the new setting you want (
Fig.
4b
), then press ENTER to “Execute” (make the actual change to this setting). If you want to confirm this
setting is now the current one, just press the
RIGHT
key to scroll to the next parameter, then press
LEFT
to go back again to the previous one. You should see the parameter setting you just made.