Bushnell 119519, Инструкция по эксплуатации

Страница: 10 / 192

10
to the SETUP position will turn on the LCD display, and you will see an
information screen that shows how many images have been taken, the
battery level, camera or video mode, etc
(see Fig. 3, next page) .
NOTE: Always move the power switch from
OFF
to
SETUP
mode. It
is possible that the camera could lockup if it is switched from ON to
SETUP
mode. If this occurs, simply move the switch to
OFF
and then
push it up to SETUP again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in “Parts & Controls”, some of the keys below the
LCD have secondary, “shortcut” functions when the camera is switched to
SETUP mode (but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
• Press the UP key again to quickly set the camera to take still photos.
• Press the RIGHT key to manually trigger the shutter. This is useful
for testing the camera-make sure you are in SETUP mode, press the
RIGHT key, and a few seconds later a photo or video (depending on
how the camera was set) will be saved to the SD card (or internal
memory if no card is inserted). The “number of images taken” counter
on the bottom left of the LCD will increase by one. If the display
indicates “SD PROTECTED” when you press the SHOT key, switch
the camera OFF, remove the SD card and slide its protect switch off.