8
PROPANE GAS CONNECTION
The freezer is designed for operation on Propane Gas, the pressure of which must be 2.75kPa. Check that this
is stated on the dataplate. The freezer is
NOT
designed for operation on town gas or natural gas.
CAUTION! CHECK THAT THE GAS SUPPLIED TO THE FREEZER IS AT THE PROPER
PRESSURE. SEE THE PRESSURE REGULATOR ON THE PROPANE GAS CONTAINER.
This appliance shall be installed only by authorised persons and in accordance with the manufacturer's
installation instructions, local gas fitting regulations, municipal building codes, AS/NZS 5601 - Gas
Installations and any other statutory regulations.
The gas supply pipe should be connected to the gas inlet of the gas control valve by means of a suitable
threaded coupling.
The appliance can be connected with rigid pipe as specified in AS/NZS5601 or with a
Flexible Hose, which complies with AS/NZS 1869 (Australian Certified), 8mm ID, class B or D, no more than
1.2m long and in accordance with AS/NZS 5601.
In making the connection to the freezer, a union gas cock of an approved bottled-gas type must be incorporated
in the supply line in a position which is readily accessible to the user. For eventual servicing purposes, the
union should be on the outlet side of the cock and the pipework should be positioned so as not to prevent the
freezer from being readily withdrawn.
AN APPROVED MANUAL SHUT-OFF VALVE MUST BE INSTALLED AT THE GAS INLET OF THE
FREEZER. THE SHUT-OFF VALVE MUST BE ACCESSIBLE TO THE USER WHEN THE
APPLIANCE IS IN THE INSTALLED POSITION.
BEFORE LEAVING
–Check all connections for gas leaks with soap and water. DO NOT use a naked flame
for detecting leaks. Ignite the burner to ensure correct operation of gas valve, burner and ignition. Turn gas tap
to low flame position and observe stability of the flame. When satisfied, please instruct the user on the
correct method of operation. In case the appliance fails to operate correctly after all checks have been carried
out, refer to the authorised service provider in your area.
