Bush WC52, Инструкция по эксплуатации, Страница: 13 / 28

The installation of this appliance is best carried out
by 2 people.
Dispose of all packaging carefully and responsibly.
The appliance is designed for indoor use only and
must be protected from rain, moisture and extreme
temperature variations.
This appliance is designed for household use. Do
not use the appliance for industrial and commercial use,
or any other purpose.
The appliance MUST be positioned on a firm level
base.
Installation of your appliance
The appliance is designed for built-in, recessed or free standing
installation. The minimum space required is :
615mm W x 605mm D X 830mm H ( refer to right photo)
IMPORTANT: Failure to follow the instructions regarding installation
and ventilation may void the warranty supplied with your
appliance.
10mm
30mm
615
61
0
8
3
0
-8
9
0 595
57
5
8
2
0
~
8
8
0
90
3
0
13
To install the handle, follow the instructions below:
1. Peel back door seal along the right hand side
of door. You will find a screw hole at the top
and lower of the door where you have
peeled the seal back. (please refer to
the diagram)
2. Take out the screws from bag at back
of cabinet. Put the screws in the hole
where the handle is to be installed.
(Screw hole position please refer to
Point 1).
3. Align the handle with screws,
tighten the screws using a screw
driver until the handle is both flush
and secured tightly against the
door side. (DO NOT over-tighten as
this may cause damage to the door surface)
4. After handle fixed well, put the door seal back to
the door to cover the hole.
Installing the stainless steel handle
Door seal