Bush VUS34AE2O, Инструкция по эксплуатации

Страница: 30 / 36

TROUBLE SHOOTING
In case of malfunction, please refer to the following table.
.
Problem Solution
Motor will not start. - Push plug securely into outlet, try another outlet or check
circuit breaker.
- Step on power switch to turn vacuum on.
- See detailed "thermal cut-off" instructions above.
Vacuum cleaner does
not clean carpet.
- Empty dust container, clean and/or change filter.
- Clean or replace filter regularly to maintain suction.
- Check vacuum height adjustment knob position.
- Clean brush roll bar if needed.
No suction at the
end of hose or wand.
- See other solutions above.
- Remove clogs from the hose or wand that restrict the airflow.
Vacuum is hard to push. - Adjust vacuum height knob to a higher position.
Burning smell; brush roll bar
will not turn.
- Check brush roll bar for debris.
- Replace broken or out of shape belt.
- Refit the belt.
NOTICE: Thermal cut-off
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor
overheating.
If the vacuum suddenly shuts off,
proceed as follows: 1) Push the power switch to off and
unplug the vacuum. 2) Check the vacuum for a possible source of overheating such as a full
dust container, blocked hose or clogged filter. If these conditions are found, fix them and wait
at least 30 minutes before attempting to use the vacuum. 3) After the 30 minute period, plug
the vacuum back in and turn on the switch. If the vacuum still does not work, call the
customer service helpline.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting section of these instructions
30
Product support
Help is always at hand