Bush DLED49FHDS, Инструкция по эксплуатации

Страница: 53 / 57

Troubleshooting & Tips
TV will not turn on
Make sure the power cord is plugged in securely to a wall
outlet. Press the Power button on the TV.
Poor picture
• Check if you have correctly tuned the TV.
• Low signal level can cause picture distortion. Please
check antenna connections.
• Check if you have entered the correct channel frequency
if you have performed manual tuning.
No picture
• TV is not receiving any signal. Make sure the correct
source has been selected.
• Is the antenna connected properly?
• Is the antenna cable damaged?
• Are suitable plugs used to connect the antenna?
• If you are in doubt, consult your dealer.
No sound
• Check if the TV sound is muted. Press the Mute button
or increase the volume to check.
• Sound may be coming from only one speaker. Check
the balance settings from
Sound menu.
Remote control - no operation
• The batteries may be exhausted. Replace the batteries.
Input sources - can not be selected
• If you cannot select an input source, it is possible that
no device is connected. If not;
• Check the AV cables and connections if you are trying to
switch to the input source dedicated to the connected
device.
The Image is not centered in VGA source
To have your TV automatically center the image, enter
the
PC Position menu in Picture menu highlight
Autoposition and press OK . Wait for it to finish. In order
to set the position of the image manually you can use
H Position and V position options. Select the desired
option and use Left and Right directional buttons on the
remote to set.
Product support
Help is always at hand
Product support 52
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,