Bush CBAR1000BF, Инструкция по эксплуатации, Страница: 14 / 28

Using your Soundbar
Let’s get started
Using your Soundbar
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Standby mode
This unit is designed to enter STANDBY mode
automatically after 20 MINUTES (approximately) of
inactivity. Press the STANDBY button to wake the
unit.
4. Press and hold the STANDBY button on the unit (1)
or press the STANDBY button on the remote to put
the system into standby mode.
5. To wake from standby press and hold the
STANDBY button on the unit (1) or press the
STANDBY button on the remote
Switching inputs
Follow the below steps to switch inputs between :
Bluetooth, Auxiliary or Optical.
1.
Ensure the Sound bar is powered ON. If not press
and hold the STANDBY button on the unit (1) or
press once on the remote.
2.
Press the SOURCE button on the unit (1) or remote
repeatedly until you reach the required input mode
• Bluetooth input Blue/Blue Flash
• Auxiliary input Orange
• Optical input Green
Adjusting the volume
1.
To increase the volume level press and hold the
button on the main unit (3) or remote.
2. To decrease the volume level press and hold the
VOLUME- button on the main unit (4) or remote.
EQ presets
NOTE: EQ sound modes are only available in
Bluetooth mode.
1. During playback pressing the EQ button on the
remote control repeatedly cycles through the
available sound EQ modes.
Mute function
1.
Pressing the MUTE button on the remote will
temporarily silence the audio output.
2. Press the MUTE button again to resume the audio
output.
Pairing a bluetooth device
Before you can use the sound bar with your phone or
other bluetooth capable device you will need to pair
the device to the sound bar.
1.
Press the SOURCE button on the main unit (1) or
remote control until you see a blue flashing light
appear to the right of the soundbar and you hear
two beeps.
2. When selected the unit tries to connect to
previously paired devices. If a paired device is
found and connected the blue light will stop
flashing and remain solid. If no devices are found
the blue light will continue to flash.
3. Enable the Bluetooth function on your audio
device and search for a device labelled ‘BUSH
CBAR1000BF’ in the available list.
4. Select and enable pairing for the ‘BUSH
CBAR1000BF’ device. If prompted for a password
enter ‘0000’.
5. If pairing is successful the sound bar will play a
chime and the blue light will stop flashing and
remain solid.
6. If the connected device goes out of range, the
sound bar will attempt to connect. When the
device comes into range the sound bar will
reconnect again automatically.
7.
To remove a paired device using only the sound
bar, press the UNPAIR button on the remote
control. The blue light will begin flashing again.