Installation
Transportation
Caution:
2 people are required to unpack
and handle the appliance, it is recommended that
gloves are worn.
y
The appliance should be transported only in
an upright position. Do not tilt the appliance
greater than 45
°
. The packaging as supplied
must be intact during transportation.
y
After transporting the appliance, leave it for at
least 4 hours before switching on to allow the
cooling system to settle. Failure to comply
could result in damage to the appliance.
y
Do not move the appliance by pulling the door
or handle as it may damage your flooring and
wall coverings etc.
y
Ensure the supply cable is not caught under
the appliance during and after moving.
y
Carefully remove all packaging materials
including the foam base, dispose of correctly.
y
Ensure sufficient spacing is provided for the
appliance to be installed. Leave space on
both sides (15cm), back (20cm) and above the
appliance (30cm) to ensure proper ventilation.
y
Do not place the appliance near a heat source
or in direct sunlight.
y
Do not put any heavy objects on top of the
appliance. It will damage the appliance.
y
Do not install the appliance in moist and wet
place.
y
It should be installed on a smooth surface to
avoid excessive vibration and noise.
y
Each appliance has a climate class (shown on
the rating plate) where it indicates the
temperature range of the appliance operation
in place. The appliance may not work properly
if it is left for a long period at a temperature
outside the specified range.
y
Refer to section “Care and Maintenance” to
prepare your appliance for use.
Climate Class
Amb. T. (
°
C)
Amb. T. (
°
F)
SN
10 ~ 32
°
C
50 ~ 90
°
F
N
16 ~ 32
°
C
61 ~ 90
°
F
ST
16 ~ 38
°
C
61 ~ 100
°
F
T
16 ~ 43
°
C
61 ~ 110
°
F
Installation
4