If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions,
14
Installing and operating your
refrigerator
Before starting to use your refrigerator, you should
pay attention to the following points:
• Operating voltage for your refrigerator is 220-
240 V at 50Hz.
• We cannot be responsible for any damages
that occur to this product if used incorrectly.
• Do not place your appliance in direct sunlight.
• Your appliance should be at least 50 cm away
from stoves, gas ovens and heater cores, and
should be at least 5 cm away from electrical
ovens.
• Your refrigerator should never be used
outdoors or exposed to rain.
• When your refrigerator is placed next to a
deep freezer, there should be at least 2 cm
between them to prevent humidity on the
outer surface.
• When installing the refrigerator, chose a
suitable place and ensure that there is a least a
15cm gap between the top of the refrigerator
and the counter. Please do not place
anything on top of the refrigerator.
• The adjustable front legs should stabilized
in an appropriate height to allow your
refrigerator operate in a stable and proper
way. You can adjust the legs by turning them
clockwise (or in the opposite direction). This
should be done before placing food in the
refrigerator.
• Before using your refrigerator, wipe all parts
with warm water added with a tea spoonful of
sodium bicarbonate, and then rinse with clean
water and dry. Place all parts after cleaning.
• Install the distance adjustment
plastic (the part with black vanes
at the rear) by turning it 90° as
shown in the figure to prevent the
condenser from touching the wall.
• Refrigerator should be placed against a wall
with a free distance not exceeding 75 mm.
Before using your refrigerator
• Before switching on your appliance for the
first time, ensure it is positioned in it’s desired
final location and is in it’s upright position
for at least 3 hours before plugging in and
switching on the power. Otherwise you may
damage the compressor.
• You may experience a odour from the
appliance when it is operated for the first
time. This is normal and will fade when your
appliance starts to cool.
Shipment and repositioning
• Original package and foam may be kept for
retransportation (optionally).
• You should fasten your refrigerator with thick
package, bands or strong cords and follow
the instructions for transportation on the
package for retransportation.
• Remove movable parts (shelves, accessories,
vegetable bins etc.) or fix them into the
refrigerator against shocks using bands during
repositioning and transportation.
Carry your refrigerator in the upright position.
Installing your Built-In Refrigerator
Installing your Built-In Refrigerator
Bringing it all together