Bush Palace
Flamingo
Setup Guide
© 2017 Bush Palace Camper Hire
10
IF YOU ARE FREE CAMPING….
I.e. there is no mains water/240v power available. In this case you are reliant on the 82l water tank,
the 2 x 100a/h batteries, and the 9Kg gas cylinder.
•
Make sure water tank is full. It is filled via the filler inside the small white door at the rear of the
right side of the camper.
•
Switch on the water pump using the switch (under table)
•
Turn on the gas bottle in the front boot, making sure to push down on the gas fuse once turned
on.
Hot Water (Gas)
•
Outside camper, open the hot water cover and make sure switch is set to OFF
•
Inside camper, ensure battery switch and water pump are on (under table)
•
flick tap to hot and ensure water is flowing
•
Turn on the white ‘Water Heater’ switch inside the camper. A red light will ignite and remain lit
until the hot water burner has ignited. Turn switch off when not in use.
•
Do not light the hot water with no water in the tanks.
•
HWS takes ~20 minutes to heat water
Gas hot water switch &
battery switch
