Bush Palace
Eagle
Setup Guide
© 2017 Bush Palace Camper Hire
7
SETTING UP THE BEDS
•
Pull the rear bed out fully
•
Using the support poles stored under mattress, support the bed end by placing one end of each
pole into the bracket on the bumper and the other into the bracket under the bed. You may
need to lift the bed slightly as you do this
•
Close front boot and repeat for front bed
•
At each corner cover the riser arms with canvas flap and Velcro closed
•
Pull step out from under door
•
Unlock the door and enter the camper
•
Remove BBQ and stand (they are only stored here for travel)
•
Turn battery switch on
•
Plug in roof light connector (behind sink)
•
Raise the wardrobe and lock into place using the bolt inside
•
Using the crook shaped pole (under the mattress), insert into plastic fitting in the rear bed hoop
and raise the roof of the bed. Insert the other end into the bracket on roof and close Velcro flap.
•
Do the same for front bed
•
Pull the corners of the canvas down over the bed ends and secure with velcro
Velcro to bed base
Front Supports
Rear Supports
Roof light connector
Wardrobe in place
Bed roof in place
Battery switch
