Bush Hog HDC-2 Series, Руководство оператора, Страница: 52 / 104

CONTROLS
CONTROLS
HDC2 ZT 04/18 Controls Section 3-6
© 2018 Alamo Group Inc.
Seat Adjustment Controls
NON-SUSPENSION SEAT
The Non-Suspension Seat can be adjusted forward or
backward to fit the operators need. The adjusting lever is
located under the front right hand side of the seat. Move
the lever to the left as seen from the driver in the seat to
move the seat backward or forward.
The Transaxle Bypass Linkages must be pulled out
when pushing or pulling the Zero Turn Mower without en-
gine power. The linkages are located at the rear of the
Zero Turn Mower under the engine plate. The linkages
must be pulled out and locked in order to relieve hy-
draulic pressure so the Zero Turn Mower can be moved.
Refer to
Moving the Zero Turn by Hand in the Opera-
tion Section.
NOTE: The Tansaxle Bypass Linkages must be disen-
gaged in order for the Zero Turn Mower to move forward
or backward under its engine power.
The Bypass Linkage is located close
to the muffler. To prevent burn injury,
turn the engine off and allow the engine and muffler to
cool down before handling the Bypass Linkage
.
Move Lever
to left to
adjust.
Transaxle Bypass Control
Transaxle Bypass Linkages
! CAUTION
2. The Backrest Angle Adjustment Knob.
3. Arm Rest Height adjustment (raise arm rest to access
adjustment knobs).
4. Seat Slide allows 6” of fore and aft adjustment.
.
The seat is shaped to increase air flow so that you stay
more comfortable on hot days
1
2
3
4
NON-SUSPENSION SEAT
FULL SUSPENSION SEAT
FULL SUSPENSION SEAT
1. The Weight Adjustment Knob lets you set a personal-
ized suspension setting.