BUSCH MINK MM 1102 BP, Инструкция по эксплуатации

Страница: 18 / 24

11 | Troubleshooting
18 / 24 0870139163_MM1104BP,MM1144BP,MM1102BP,MM1142BP_A0001_IM_en
SCH
Mink
BU
IS
CPL
SV
Problem Possible Cause Remedy
The machine does not start. The motor is not supplied
with the correct voltage.
• Check the power supply.
The motor is defective. • Replace the motor.
The coupling (CPL) is de-
fective. • Replace the coupling
(CPL).
The machine does not reach
the usual pressure on the
discharge connection. The inlet screen (IS) is par-
tially clogged. • Clean the inlet screen (IS).
The inlet filter cartridge (op-
tional) is partially clogged. • Replace the inlet filter
cartridge.
The pressure system or pres-
sure line is not leak-tight. • Check the hose or pipe
connection for leakage.
The pressure relief valve/
regulating system (SV) is
misadjusted or defective. • Adjust, repair or replace,
respectively.
Internal parts are worn or
damaged. • Repair the machine (con-
tact Busch).
Partial clogging in the dis-
charge or pressure line. • Remove the clogging.
The machine runs very nois-
ily. Worn coupling (CPL). • Replace the coupling
(CPL).
Oil level too low. • Top up oil.
Defective bearings. • Repair the machine (con-
tact Busch).
The machine runs too hot. Insufficient cooling. • Remove dust and dirt
from the machine.
Ambient temperature too
high. • Observe the permitted
ambient temperature, see
Technical Data [ ► 19] .
Temperature of the process
gases at the inlet too high. • Observe the permitted
gas inlet temperature, see
Technical Data [ ► 19] .
Oil level too low. • Top up oil.
For the solution of problems not mentioned in the troubleshooting chart contact your
Busch representative.