BUSCH BFSLSAE9W, Инструкция по эксплуатации

Страница: 27 / 39

Using your Dishwasher
Getting the most from your appliance
Using your Dishwasher
2 7
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
performance. The amount of detergent
needed depends on the cycle, load
size, and soil level of dishes.
Do not fill detergent into the detergent
compartment more than required;
otherwise you can see whitish streaks
or bluish layers on glass and dishes and
may cause glass corrosion. Continued
use of too much detergent may cause
machine damage.
Using little detergent can result in
poor cleaning and you can see whitish
streaksin hard water. See the detergent
manufacturer’s instructions for a
further information.
4.9. Filling the detergent
Push the latch to open the dispenser
and pour in the detergent. Close the
lid and press it until it locks in place.
The dispenser should be refilled just
before the start of each programme.
If the dishes are heavily soiled, place
additional detergent in the pre-wash
detergent chamber.
DETERGENT
4.10. Using combined
detergents
These products should be used
according to the manufacturer’s
instructions.
Never put combined detergents into
the interior section or the cutlery
basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the
combination.
We recommend you do not use
combined detergents in short
programmes. Please use powder
detergents in such programmes.
If you encounter problems when using
combined detergents, please contact
the detergent manufacturer.
When you stop using combined
detergents, make sure that water
hardness and rinse aid settings are set
to the correct level.
4.11. Rinse-aid usage
The rinse aid helps to dry the dishes
without streaks and stains. Rinse-aid is
required for stain-free utensils and
clear glasses. The rinse aid is
automatically released during the hot
rinse phase. If rinse aid dosage setting
set too low, whitish stains remains on
dishes and dishes do not dry and
washed clean. If rinse aid dosage
setting set too height, you can see
bluish layers on glass and dishes.
4.12. Filling the rinse -
aid and setting
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to
the MAX level and then close the cap.
Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid level,
follow the below steps:
•
Push the programme button and
hold it down.
• Turn on the machine.
• Hold down the programme
button until “rA” disappears from
the display. Rinse aid setting
follows water hardness setting.
• The machine will display the last
setting.
• Set the level by pushing the
programme button.
• Switch off the machine to save
the setting.
• The factory setting is “4”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease level.
Level Brightener
Dose
Indicator
1 Rinse-aid not
dispensed
r1 is shown on
the display.
2 1 dose is
dispensed
r2 is shown on
the display.
3 2 doses are
dispensed
r3 is shown on
the display.
4 3 doses are
dispensed
r4 is shown on
the display.
5 4 doses are
dispensed
r5 is shown on
the display.