Burstner Ixeo Time IT 590, Инструкция по эксплуатации

Страница: 160 / 274

160
T-Modell - 17/18 - Ausgabe 09/17 - 2891569 - BUE-0029-19EN
Appliances
9
9.2.6 Electrical floor warming unit (special equipment)
The transformer (Fig. 205,1) for the electrical floor warming unit is installed
either in the bench seat or in the bedding box, depending on the model.
Switching on:
„
Connect the vehicle to the 230 V power supply (see chapter 8).
„
Press the rocker switch (Fig. 206,2). The indicator lamp (Fig. 206,1) on the
switch is illuminated.
Switching off:
„
Press the rocker switch (Fig. 206,2). The indicator lamp (Fig. 206,1) on the
switch goes off.
After switching off, the floor remains warm for a while, due to residual heat.
If the transformer is overloaded, the overload protection is actuated. The pin
(Fig. 205,2) jumps out.
Switching on overload
protection:
„
Press the pin (Fig. 205,2) on the overload protection when the transformer
is cooled.
9.3 Air conditioning unit (special equipment)
9.3.1 Truma Aventa air conditioning unit
X
On models with electrical floor warming unit, never drill holes in the floor
or screw in any screws. Careful with sharp objects. There is danger of a
power cut or a short circuit due to damage to a heater wire.
Z
Do not cover the transformer. Danger of overheating!
Z
The electrical floor warming unit only operates if the vehicle is connected
to the 230 V power supply.
Z
The output of the electrical floor warming unit alone is not sufficient to heat
the living area.
Fig. 205 Transformer for electrical floor
warming unit
Fig. 206 Switch for electrical floor
warming unit
Z
The cooling circuit may only be opened by the manufacturer or an author-
ised workshop.
Z
Do not block the air inlets and air outlets.