10
HDLG HD/SD SDI Logo Generator / Color Bar Generator
Daylight Saving Time Setup
Use this item to set your local Daylight Savings Time. Click on this item and follow the onscreen
instructions to properly set Daylight Savings for your location.
GPI Setup: Mode = #: CTRL = #
This item opens the Schedule Mode & GPI Control Setup Menu. On the left are listed the different
configurations for how the front panel "TAKE" switch and rear panel GPI input control the operation of
Schedule and logo selections. On the right are listed the different control options for the GPI input. Once
you have selected the Mode and Control options, click Save & Update to send these changes to the
HDLG.
GPI Mode
1. Scheduler: Front panel controlled/GPI: Disabled
- Pressing down on the front panel TAKE switch
activates Schedule. GPI Controls are disabled from controlling either Schedule or selecting logos.
2. Scheduler: Front panel disabled/GPI: Control Scheduler
- Pressing down on the front panel TAKE
switch does not activate Schedule. GPI input controls activation of Schedule.
3. Scheduler: Front panel controlled/GPI: Overrides Scheduler with Logo ON
- Pressing down on
the front panel TAKE switch activates Schedule. GPI Control turns the currently selected logo ON.
4. Scheduler: Disabled/GPI: Sequences through Logos 1-2-3-4-1
- Pressing down on the front panel
TAKE switch does not activate Schedule. Each time the GPI Control is activated, the next logo in line will
turn on and be displayed over video. When the GPI Control is removed, the currently selected logo will
turn off.
5. Scheduler: Front panel controlled/GPI: Forces Logo 4 ON
- Pressing down on the front panel
TAKE switch activates Schedule. GPI Control overrides Schedule and activates the logo stored at Logo 4.
Removing GPI Control will allow Schedule to continue to run normally.
GPI Control
1. Active when closed
- A constant contact closure required.
2. Active when open
- A constant contact open required.
3. Pushbutton (Pos edge)
- A momentary contact closure where the positive going edge of the GPI
signal toggles activation of the GPI Mode.
4. Pushbutton (Neg edge)
- A momentary contact closure where the negative going edge of the GPI
signal toggles activation of the GPI Mode.
Help
User Guide (HDLG-Manual.PDF)
- Provides a link to the HDLG User's Manual in PDF format originally
included during installation of this software.
About
- Opens the information window for this version of HDLogoGen. This also provides Burst
Electronics' telephone numbers and email address for technical support.
Terminal
- Opens a small window that allows you to monitor the communications between the PC and
HDLG.
HDLogoGen Copyright
- Commands the HDLG to display the Copyright and firmware information
through the Terminal window.
