- 4 -
9. Sliding Reference Shelf
(optional)
a. Sliding reference shelves should be located at a
convenient working height or positioned to suit
conditions of assembly for shelf filing.
b. The slides and brackets are pre-assembled and
attached to the shelf.
c. Double entry unit brackets are bolted to supports, as
above, with a separate sliding reference shelf on
each side of unit. Brackets have backstops, with
rubber bumpers at center, to stop shelf travel.
d. Shelf supports, from which reference shelf hangs,
must have four (4) safety plugs inserted in keyholes
above the shelf covering the supports to prevent shelf
and supports from lifting when the sliding reference
shelf is fully extended. (See Step 10A.)
11. Wall & Floor Anchors
a. Optional wall anchors are used for anchoring sections
to walls and are inserted into top of angle or T upright
at posts against the wall. Fastener used into wall
should suit type of building construction material used.
b. Optional floor anchors are used for securing section to
floor and are attached to upright post with screws (field
drilled) or welded. Anchor plate has two (2) holes for
lag screws or expansion anchors to suit type of floor.
10. Small Parts
a. Safety plugs prevent shelf and shelf
support from lifting.
b. "U" clips secure back-to-back units
at bottom of angle or T uprights.
c. Clothespin clips are used at top of
angle or T uprights to join units
together.
Form #53-50423-00A • April 2004
STEP 9
3002 N. BURDICK STREET
KALAMAZOO, MI 49004-3483
800-748-0227
FAX: 269-342-4161
www.borroughs.com
STEPS 10 A & B
STEP 10 C
STEP 11A
STEP 11B
