burroughs ReceiptNOW, Руководство пользователя, Страница: 14 / 32

Burroughs ReceiptNOW
TM
User Manual
- 12 -
4.7 Printer power on and self test
1) Make sure power cable is connected to the printer and the paper roll is loaded.
2) Make sure POWER INDICATOR LIGHT is off and printer is powered off.
3) Hold down the feed key while turning the printer on. The printer will perform a self-test and then print
‗Press and Release FEED key to print characters‘ and ‗Press and Hold FEED key to configure the
printer
‘. The printer will change to holding state and PAPER INDICATOR LIGHT blinks.
4) When the self-test page is finished, press the FEED key briefly to print test characters or hold the
FEED key down to configure the printer. For specific function and operational approach for using the
FEED button to configure the printer, please refer to Appendix A
―Parameter Setting by FEED Button‖.
4.8 Ethernet IP Address Configuration
ReceiptNow printers that have an Ethernet interface are factory configured for a default IP address of
192.168.1.251. Changes to the unit‘s default IP address or to set the unit for DHCP mode can be done by
communicating with the unit via a web browser set to the default IP address as shown in the screen shot
below. The web browser utility can also provide printer and interface status.
The current IP address of the printer can be determined by powering on the printer while holding the feed
button down which will cause the printer to print out a test form which lists various hardware and
communication interface parameters.
If the printer does not appear to respond to the proper IP address, the most likely cause is that the printer
is not currently configured in a manner that is compatible with the network to which it is connected.
Check with your network system administrator to insure that the settings for ‗DHCP‘, ‗Gate Way‘ and ‗IP
Address‘ are compatible with the network.