•
The belt is properly tensioned when a force of approximately 5 pounds will deflect the belt
approximately ¼ inch near the center of the belt track.
•
Tighten the two elastic nuts and reinstall the cover plate.
Vacuum or otherwise remove dust and debris build-up regularly from the machine,
There are no other maintenance actions required. All bearings are sealed for life and require no lubrication.
------------------------------------------------------------------------------------------------------------
Remember for operator safety and the continued effectiveness of your Model 1001:
Do not defeat the safety guards and other safety provisions of the Model 1001.
Do not reach inside the safety guards while the machine is running. To do so is hazardous.
Do not use fluids in your buffing process unless your Model 1001 is designed for liquid operation (NEMA
4, 4X). To do so may create an electrical safety hazard.
Do not use your Model 1001 to polish explosive materials unless it is equipped with explosion proof
electrical devices and motor.
Do not mix alloys in your buffing. To do so may create an explosion hazard.
Do not use stone or vitreous wheels on the Model 1001. To do so will create an operator safety hazard.
Do use eye, hand, face, arm, leg, feet and body protection that is adequate to protect against flying debris,
forcibly ejected work pieces, etc.
Do not wear loose fitting, of hanging clothing that might become entangled in the rotating wheels, or
shafts.
Do train operators and others in safe operating practices.
Post these or equivalent instructions such they are available for ready operator reference.
For spare parts, or other assistance contact your Burr King distributor; or, contact Burr King Manufacturing at
660-438-8998.
Wear proper clothing and
personal protection
equipment we operating
Page 12
