BURNHARD 943126, Руководство пользователя

Страница: 43 / 52

43
CONNECTING THE GAS CYLINDER
Fire and explosion hazard
WARNING: Never connect new or not completely empty gas cylinders if there are ignition sources in the
immediate vicinity. Do not smoke.
The following parts are included. They comply with the applicable standard of the country in which the
gas grill is supplied:
• Gas hose (pre-assembled): CE-approved hose line of sufficient length (maximum 1.5 m) that allows
kink-free installation.
• Pressure regulator (pre-assembled on the gas hose): Permanently adjusted and CE-approved pressure
regulator in accordance with DIN EN 16129, max. 1.5 kg/h, operating pressure 50 mbar, suitable for the
gas cylinder used.
1. Screw the coupling nut on the end of the hose onto the screw thread on the gas connection on the
gas grill. Use a spanner to tighten the coupling nut.
2. Place the gas cylinder in the trolley.
3. Screw the coupling nut of the hose onto the fitting on the pressure regulator and tighten the connec-
tion with a spanner.
4. Screw the coupling nut on the pressure regulator onto the screw connection on the gas cylinder.
Tighten the coupling nut with your hand. To prevent damage to the seal, don’t use tools.
PERMITTED GAS CYLINDER SIZES
Gas cylinder sizes that may be operated
and stored in the grill base:
5 kg (height 420 mm, diameter 200 mm)
8 kg (height 505 mm, diameter 229 mm)
11 kg (height 600 mm, diameter 300 mm)
Fire and explosion hazard due to damage to the gas hose
WARNING: When placing the gas hose, ensure that the following requirements are met:
• The gas hose does not touch any hot surfaces.
• The gas hose does not run along sharp edges and corners.
• No hot grease can drip onto the gas hose.
• The gas hose is not twisted at any point.
Diameter
Height