background image

2

The following terms are used throughout this manual to bring attention to the presence of hazards of various risk levels.

Basic Operation

A.

  General

1.  This manual covers the proper care and use of the 

Alpine™ (ALP) Condensing High Efficiency Gas 

Fired Boiler

2.  Instructions to safely light and shut down this boiler 

are shown on page 4, as well as on a label affixed to 

the boiler.  Control locations shown in Figure 1.

3. 

The Alpine™ (ALP) boilers

 use an electronic 

means built into the ignition system to extinguish 

the burner in the event that flames exit the 

combustion chamber. If the boiler fails to fire, call 

a qualified heating service agency to diagnose and 

correct the problem.

4. 

Alpine™ (ALP) boilers – 

These boilers are 

equipped with a safety feature which will shut down 

the burner in the event that there is a blockage in 

the vent system. In the event that the boiler fails to 

function, and the boiler is vented through an outside 
wall accessible from the ground, inspect the vent 
terminal on the outside wall for a blockage such 
as a bee’s nest or ice. If a blockage is found, the 

burner should ignite approximately 30 seconds after 

the blockage is removed. If no blockage is found, 
or if the terminal is inaccessible from the ground, 

the problem must be diagnosed and corrected by a 

qualified gas service technician. 

DANGER

There are no user serviceable parts on this boiler.  Attempts to service this boiler by someone other  than a 

qualified gas service technician could void the warranty, cause property damage, personal injury or loss of 

life.

CAUTION

Should overheating occur or the gas supply fail to shut off, do not turn off or disconnect the electrical 

supply to the pump. Instead, shut off the gas supply at a location external to the appliance.

En cas de surchauffe ou si I'admission de gaz ne peut étre coupée, ne pas couper ni débrancher 

l'alimentation électrique de la pompe.  Fermer plutôt le robinet d'admission de gaz à l'extérieur de I'appareil.
Do not use this boiler if any part has been under water. Immediately call a qualified service technician to 

inspect the boiler and to replace any part of the control system and any gas control which has been under 

water.

CAUTION

Like all central heating appliances, this boiler is equipped with safety devices, which could cause it to 

shutdown, requiring service to restore normal operation. Where such a shutdown could result in damage 

from low temperatures (such as frozen pipes), do not leave the heating system unattended during cold 

weather unless alarms or other safeguards are in place to prevent damage.  

WARNING

Indicates a potentially hazardous situation which, 

if not avoided, could result in death, serious injury 

or substantial property damage.

CAUTION

Indicates a potentially hazardous situation which, 

if  not  avoided,  may  result  in  moderate  or  minor 

injury or property damage.

Содержание Alpine Series









Отзывы: