Bill of materials (not included):
• Thick/medium viscosity CA
• PL adhesive, or Gorilla Glue Heavy Duty Construction adhesive (or similar plastic safe adhesive)
• 256 thread cutting screws
• 1/16" brass rod
• .025" phosphorbronze wire
• .015 x .125" styrene
• .080 x .125" styrene
• .020 x .100" styrene
• .060 x .188" styrene
• Chain, 15 links per inch (For the brakewheel/brake cylinder jewelery chain works well, the cheaper the better)
Tools required:
• 5/64" drill bit
• 3/32" drill bit
• 1/16" drill bit
• 1.5mm drill bit
• #65 drill bit
• 123 blocks, or a small square
Resin preparation:
When gluing resin components, if possible, rough up the glue surface first with medium (160200 grit) sandpaper for a better bond.
Large resin components may have small bubbles on their backs. Sanding the back may make them more pronounced. This is normal.
Storage of resin parts:
Keep resin components out of direct sunlight, unless painted. Always store them flat on their backs. Avoid storage in an excessively hot
environment (such as an attic).
