Bürkert 8696, Руководство по эксплуатации

Страница: 36 / 75

36
Installation
→
For version with plug-in hose connector, remove the collets (white nozzles) from both pilot air ports (if
present).
Spindle extension
O-ring
Guide element
Actuator cover
Groove ring
Puck
Switch spindle
max. 5 Nm
max. 1 Nm
Figure 16: Installing the switch spindle, series 2103, 2300 and 2301
ATTENTION!
Improper installation may damage the groove ring in the guide element.
The groove ring is already be pre-assembled in the guide element and must be “locked into position”
in the undercut.
▶
When installing the switch spindle, do not damage the groove ring.
→
Push the switch spindle through the guide element.
ATTENTION!
Screw locking paint may contaminate the groove ring.
▶
Do not apply any screw locking paint to the switch spindle.
→
To secure the switch spindle, apply some screw locking paint (Loctite 290) in the tapped bore of the spindle
extension in the actuator.
→
Check that the O-ring is correctly positioned.
→
Screw the guide element to the actuator cover (maximum torque: 5 Nm).
→
Screw switch spindle onto the spindle extension. To do this, there is a slot on the upper side
(maximum torque: 1 Nm).
→
Push puck onto the switch spindle and lock into position.
english
Type 8696, REV.2