Burkert FLOWave S 8098, Руководство по эксплуатации

Страница: 92 / 192

92
SAW sensor - Parameter
Type 8098
To activate the monitoring of the liquid velocity, do the following:
→ Select the device in the navigation area.
→
SAW sensor
→
Parameter
→
Stand. meas. values
→
Liquid velocity
→
Limits
→
Active
→
Select Yes .
The monitoring of the liquid velocity is active and the device status will change depending on the limits
that have been set.
→ You can configure the behaviour of an analogue output depending on the status of the device. See chpt.
16.3.3 Configuring the behaviour of an analogue output depending on the status of the device.*)
→
You can configure a digital output to switch every time a specific event is generated. See chpt. 16.5.1
Configuring a digital output as an on/off output.*)
→ To enable the monitoring, i.e. to be informed when the value of the liquid velocity is outside the normal
range, enable the diagnostics. See chpt. 10.9 Activating the diagnostics functions.
*
)
Only variant with outputs.
13.6.6 Deactivating the monitoring of the liquid velocity
By default, the liquid velocity values are not monitored.
If the monitoring of the liquid velocity is active, do the following to deactivate it:
→
Select the device in the navigation area.
→ SAW sensor
→
Parameter
→ Stand. meas. values
→
Liquid velocity
→ Limits
→
Active
→ Select No .
The monitoring of the liquid velocity is inactive.
English