Burkert Flowave 8098, Руководство по эксплуатации

Страница: 292 / 354

292
Outputs – Parameter
Type 8098 FLOWave L
18.4 Disabling an analogue output
If an analogue output is not wired, the analogue output can be disabled to avoid the generation of the
events
Output 1, open loop
or
Output 3, open loop
.
To disable an analogue output, do the following:
→
Go to the
CONFIGURATION
view.
→
Outputs
→
Confirm to access the Parameter view.
→
Output 1 type or Output 3 type
→
Disabled
→
Save.
The analogue output is disabled.
The menus related to the analogue output are not displayed any more.
18.5 Setting the parameters of a digital output
By default, the device has 1 digital output,
Output 2:digital
, that is configured as a pulse output.
The output 3 can also be configured as a digital output: see chapter 18.2 .
A digital output can be configured:
• as an on/off output,
• or, to switch depending on two threshold values,
• or, as a frequency output,
• or, as a pulse output.
Table 44: Default parameters of the digital output
Parameter Default value DN of process connections
Mode Pulse all the diameters
Max. pulse time
65 ms all the diameters
Max. frequency 2000 Hz all the diameters
Pulse mode Pulses/volume all the diameters
English