Burkert 8745 MFC Ethernet, Руководство по эксплуатации

Страница: 41 / 70

41
Electrical installation
Type 8745 Ethernet, 8745 Analogue
→
Do the functional earthing of the product. Refer to chpt. 8.7.
→ Connect the product to the Industrial Ethernet network:
•
If the EtherCAT protocol is used, then plug the incoming Eth -
ernet cable (coming from the PLC) into the ETH1-port and plug
the outgoing Ethernet cable into the ETH2-port.
•
If a protocol other than EtherCAT is used, plug an Ethernet
cable in any or both ports.
Both RJ45 ports have the same pin assignment. Refer to Fig. 24.
The cable shield is connected by the housing of the
RJ45 ports.
rJ45 port assignment
12345678
1 TX+
2 TX–
3 RX+
4 Not used
5 Not used
6 RX–
7 Not used
8 Not used
Housing FE
Fig. 24: Pin assignment of an RJ45 port
→
Change the network parameters. To change the network
parameters, you can use one of the following means:
-
Bürkert Communicator software. Refer to chpt. 8.4.
- product web-server. You can only use the web server if
the protocols Modbus TCP or Ethernet/IP are active on the
product. Refer to chpt 8.4.
- the BOOTP protocol or the DHCP protocol, but only if the
product uses the Ethernet/IP protocol. You must first acti -
vate the feature on the product with the Bürkert Communi -
cator software.
- any other tool that is connected to the Industrial Ethernet
network. The tool must be compatible with the protocol that
is active on the product.
→ After the parameters have been changed, restart the product
to take the new parameters into account. To restart the
product, de-energise and energise again the product.
8.4 Change the network parameters
all the product variants ethernet have the same default
ip address: 192.168.1.000
▶
Before commissioning the product, change its network
parameters.
▶
If several products must be connected to the same
Industrial Ethernet network, then connect one product
at a time and change its network parameters.
English