Burkert 6510, Руководство по эксплуатации

Страница: 18 / 36

english
Operating Instructions-No. 803 118 15
Work on the valve should only be carried out by specialist staff and with the correct
tools!
Before working on the system, always turn off the supply voltage!
Clean the piping system before installing the valve!
Where necessary, connect a strainer upstream to protect against faults.
When tightening the connections, never use the coil as a lever!
Ensure that the operational conditions agree with the performance data of the unit!
Avoid back-pressures in the exhaust channels by the use of large-volume silencers!
ATTENTION!
4 INSTALLATION, INITIALISATION AND SERVICE
Lines or valves must never be loosened while the system is
under pressure!
Manual override:
To operate the valve manually, turn the manual override by 90° in the direction of the
arrow.
4.1 Setting up block assemblies using the modular
pneumatic rails Type MP01 or MP02
With combination of two-way, three-way and twelve-way base modules, you can assemble
valve blocks of any size.
It is advisable to start the assembly with the left-most connector
module. (Fig. 1).
NOTE
ATTENTION!
Check that each module is completely pre-fitted with O-rings!
Before locking together, lightly grease or oil the fitted O-rings.
Latch the hooks of the module being added into the latching slot on the previous
module, ensuring that the O-rings are correctly seated!
Press the modules together until both hooks latch.
Lay the flat gaskets into the centering pins on the base module, ensuring that the seals
are correctly seated.
Squashed O-rings and flat gaskets sause leackages in the
block!
Secure the valves to the base module using 2 screws each.
(Tightening the screws to 30 Ncm crosswise).
Mount the complete valve block onto the wall or the standard rail.
Connect the supply and working lines.
Make the electrical connections to the pilot valves: in doing this, observe the values
given on the rating plate!