8
Insert the CR123A lithium battery with the correct polarity (positive pole
forward)
9
Slide the sleeve onto the inner knob and snap in place.
C.
Programming / Function / Operation
The keyboard can be registered to a cylinder either via the keyboard itself
or via the secuENTRY software. To operate a cylinder via a keyboard, both
units must be matched. Proceed as follows:
Registration using the keyboard
• Activate the keypad using the key
• Then press
FUNC
, the “Code Change” menu is displayed
• Scroll using the 1 or 2 keys until reaching the Administrator menu
• Confirm with
• Scroll using the 1 or 2 keys until reaching the Administrator menu setup
options "Setup"
• Confirm with
• Enter the Admin. Code of the unit to be read
• “Data has been saved” is displayed after a successful registration
Attention! Please make sure that no other powered secuENTRY unit
is placed within direct reach of the device during installation of
a new keypad or cylinder, as by mistake such unit could be
addressed instead of the intended one. When in doubt, disconnect
these units from power.
Registration via the secuENTRY software
Please refer to the operating instructions of the respective software.
Attention! For the registration of the secuENTRY pro 7116 Duo
profile cylinder, please use only the QR code of the internal knob in
the PC software. This is provided with the administrator code. It is
not necessary to register the external connector in the PC software.
secuENTRY pro 7116 Duo
English | 9
