reset button situated under the base.
Cleaning:
ALWAYS TURN OFF THE POWER SUPPLY AND REMOVE THE PLUG BEFORE
CLEANING, ALLOW THE URN TO COOL
THIS URN IS NOT WATERPROOF
DO NOT USE A WATER JET SPRAY TO CLEAN THE INTERIOR OR EXTERIOR OF
THE APPLIANCE, OR USE A WATER JET IN THE VICINITY OF THE APPLIANCE
Exterior
Clean with water and detergent. Do not use harsh abrasive cleaners as this could damage
the surface finish.
Interior
Brush any scale or sediment from the element and rinse thoroughly with clean water.
Descaling
In hard water areas scale will form on the element and interior. This will adversely affect
the operation of the urn if allowed to accumulate. Descale on a regular basis, using a
proprietary descaler recommended for stainless steel kettles. Follow the instructions
provided with the descaling product.
Scale build-up can also cause the tap to drip. If this should occur, turn off the power supply
and remove the plug. Empty the urn and allow it to cool. Unscrew the top of the tap from
the body. Wipe, scrape and break the scale away from the rubber flexible seal and from
the sealing surfaces inside the plastic body of the tap. Reassemble in reverse order.
Trouble-shooting:
Fault
Possible Cause
Remedy
The appliance does
not operate.
No power to the
appliance.
Thermostat or element
faulty.
Check supply socket is switched on.
Check fuse and circuit breaker.
Check green power indicator is
illuminated.
Replace thermostat (the element is not
intended to be replaced)
