11
Laser Grader
Attach And Detach
4. Attach And Detach
4.1 Attach Skid Steer To Grader
1.
Verify the mount plate and receiver plate are free of any dirt or debris and that the locking mechanism
pins rotate freely. Lubricate locking mechanism if necessary.
2.
Tilt skid steer mount plate (A) forward.
3.
Position mount plate into the upper lip (B) of the receiver plate.
B
C
C
A
4.
Raise skid steer loader arms slightly while tilting mount plate back at the same time. The grader should
be raised and the mount plate (A) tilted far enough back to clear the ground.
^
WARNING
Crush hazard.
If locking mechanism pins are not fully seated, the grader could fall off of the skid steer,
crushing you or bystanders.
Locking mechanism pins must be fully seated through the grader receiver plate.
5.
Engage the locking mechanism pins. Verify pins are fully seated through the receiver plate.
6.
Tilt grader back slightly and stop skid steer engine.
7.
Connect the turnbuckle chains (C) to the skid steer boom, both sides.
To set the turnbuckles, park the skid steer on a flat, concrete surface. Lower the boom all the way down.
Adjust the length of the turnbuckles and/or chains, so the grader is relatively flat or parallel with the ground
when the chains are tight.
Make sure all operators are aware of the chains. The turnbuckle chains limit the bucket tilt cylinders from
drifting during ooperation. If the skid steer boom does not have mounting points, contact your Burchland
Manufacturing dealer for turnbuckle mounting locations.
