P.6
A “
TRANSMISSION TEST
” message is sent when the test button
of the control panel is pushed.
A “
POWER SOURCE CHANGE
” message is sent when the power
source changes from 115V to the battery back-up (if the 115V
power supply stops powering the unit).
A “
LOW BATTERY
” message is sent when the battery needs to
be recharged.
A “
HIGH LIQUID LEVEL
” message is sent when the float lifts
up and triggers the alarm. This message is automatically sent a
second time five minutes after the original message and a third
time ten minutes after the original message.
A “
HIGH LIQUID LEVEL REMINDER
” message is sent every fifteen
minutes until the unit is reset. This message is only sent after the
initial “high liquid level” message has been sent and if the unit has
not been reset.
A “
RESET CONFIRMATION
” message is sent when the reset
button of the control panel is pushed (float sensor must be
pointing downwards prior to doing the reset).
A “
CONFIRMATION OF ONGOING COMMUNICATION
” message
is sent monthly to advise the owner that the connection to our
server is still active (on an hourly basis, the device sends a signal
to our server, which monitors when this message is received).
A “
LOSS OF COMMUNICATION
” message is sent when our server
stops receiving the hourly signal from your device.
2190 Dagenais Blvd. West
Laval, Quebec, Canada
H7L 5X9
TEL.:
(514)337-4415
FAX.:
(514)337-4029
TOLL FREE NUM.:
1-800 361-1820
E-MAIL :
Types of messages that can be received:
1.
2.
3.
4.
5.
6.
7.
8.
