BUNN
®
practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in centimeters.
Dimensions & Specifications
Bunn-O-Matic
®
Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • USA • +1-217-529-6601 • Fax +1-217-529-2827 • www.bunn.com
Model
Product
Dispense Rate/Sec.
Connector
Shipping
Cord
Agency
Number
1.8 oz. 2.5 oz.*
Type
Weight
Attached
Product Ratios
LCR-2A, PC Multi-Phase
36500.0054
45:1-100:1 65:1-100:1
1/8” Scholle 1910
85 lbs. (38.6 kg)
No
LCR-2A, PC Multi-Phase
36500.0055
25:1-45:1 25:1-65:1
3/16” Scholle 1910
85 lbs. (38.6 kg)
No
Phase
Volts
Amps
Watts
*Cups/hr
*Litres/hr
Single
230
13
3000
311
39
Single (2 tank heaters)
230
26
6000
620
78
Three
400/230
13
9000
932
116
*Unit shipped with dispense rate set at 1.8 oz./sec. Dispense rate increases to 2.5 oz./sec. if restrictor plug is removed.
Brewing Capacity: Measured with 5oz/125mL cup. Based on incoming water at 68˚F (20˚C) and minimum cup temperature at 185˚F (85˚C).
Electrical: Single Phase configuration requires 2-wires plus ground service rated 230V, single phase, 50/60Hz.
Three Phase configuration requires 4-wires plus ground service rated 400/230V, three phase, 50/60Hz.
Plumbing: 20-90 psi (138-621 kPa) from a
3
⁄
8
" or larger supply line. Unit requires a 2.2 gpm (8.3 litre per minute) line flow capacity. A
shut-off valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 90 psi
(621 kPa) to reduce pressure to 50 psi (345 kPa). Supplied with
3
⁄
8
" male flare fitting.
7/09 © Bunn-O-Matic Corporation
