Page 4
SKU 45891
for technical questions, please call 1-800-444-3353.
reV 04a, 07b
InstallatIon
The safe has four concrete fasteners that are inside of the safe when you open it. There
is also a mounting template included with the safe. Place the mounting template against
the area you will be mounting the safe and tape it into place.
warnIng! Before drilling or driving nails, make sure there are no wires, cables or pipes
in the path.
To attach the safe to a wood surface, hammer a nail (not included) to mark the hole
placement. Drill an 1/8” diameter pilot hole into each mounting hole location. Place the
safe over the mounting holes and secure the safe using four 1/4” diameter self-tapping
screws (not included).
To use the concrete fasteners, drill a small pilot hole through the template to mark the
hole placement. Next drill four holes in the correct location, using a concrete drill bit. Drill
the holes the same diameter as the fasteners and 2” deep. Hammer the fastener in the
hole with the flat side going into the hole first. Use a wood block between the bolt and
the hammer to protect the threads.
Place the safe over the bolts (with the nut removed from the bolts) and tighten a nut onto
each bolt. As you tighten the nuts onto the bolts, the fasteners will expand inside the
cement, securing the safe into place.
note: There are no replacement parts available for this product.
1.
2.
3.
4.
Gently remove the Panel to reveal the Secret Key-Operated Lock. Insert Emergency
Key into the Secret Key-Operated Lock and
turn. Turn Knob and pull Door open. Re-
place the keypad and the sticker when
finished. See Figure 3.
IMportant:
NEVER LOCK THE
EMERGENCY KEYS IN THE SAFE!
c.
figure 3
figure 3
