Bulls 22-15-1078, Перевод оригинальной инструкции по эксплуатации

Страница: 85 / 234

MY22B01 - 12_1.0_26.08.2021
84
Operation
6.5.4 Adjusting the saddle
6.5.4.1 Straightening the saddle
 Position saddle in direction of travel. In doing
so, align the tip of the saddle with the top tube.
Figure 83: Positioning the saddle in direction of travel
Positioning the saddle with eightpins
suspension seat post
Only applies to pedelecs with this equipment
1 Position saddle in direction of travel. In doing
so, align the tip of the saddle with the top tube.
2 Use a torque wrench to tighten the seat post
axle with 8 Nm.
Figure 84: Tightening the seat post axle
6.5.4.2 Adjusting the saddle height

To adjust the saddle height safely, either:
• Push the pedelec near to a wall so that the rider
can lean on the wall to support themselves or
• Ask another person to hold the pedelec.
1 Use the seat height formula to roughly set the
saddle height:
Seat height (
SH ) = inner leg length ( I ) × 0.9
2 Climb onto the bicycle.
3 Place your heel on the pedal and extend your
leg, so that the pedal is at the lowest crank
rotation point. Your knee should now be fully
extended.
Figure 85: Heel method
4 Take a test ride.

Riders should sit straight on the saddle at an
optimal saddle height.
• If the pelvis moves to the left and right as you
pedal, the saddle is too high.
• If your knees are painful after a few kilometres,
the saddle is too low.
 Position the seat post according to needs if
necessary. Adjust the seat height with the
quick release.