Bulls 21-17-1093, Перевод оригинальной инструкции по эксплуатации

Страница: 49 / 139

MY21B01 - 22_1.0_10.09.2020
49
Assembly
5 Check the position and clamping force of the
quick release lever. The quick release lever
must be flush with the lower housing. You must
be able to see a slight impression on the palm
of your hand when you close the quick release
lever.
Figure 50: Perfect position for the clamping lever
6 Use 4 mm hexagon socket spanner to adjust
the clamping lever clamping force if required.
7 Check the quick release lever position and
clamping force.
Figure 51: Adjusting the quick release clamping force
5.5.1.4 Quick release
Only applies to Suntour forks with quick release
1 Before installing, ensure that the quick release
flange is extended. Open the lever fully.
Figure 52: Open and closed flange
Crash caused by unfastened quick release
A faulty or incorrectly installed quick release may
become caught in the brake disc and block the
wheel. This will cause a crash.
 Never fit a defective quick release.
Crash caused by faulty or incorrectly
installed quick release
The brake disc becomes very hot during
operation. Parts of the quick release may become
damaged as a result. The quick release comes
loose. This will cause a crash with injuries.
 The front wheel quick release lever and the
brake disc must be situated on opposite sides.
Crash caused by incorrectly set clamping
force
Excessively high clamping force will damage the
quick release and cause it to lose its function.
Insufficient clamping force will result in
unfavourable transmission of force. The
suspension fork or the quick release may break.
This will cause a crash with injuries.

Never fasten a quick release using a tool (e.g.
hammer or pliers).

Only use the clamping lever with the specified
set clamping force.
CAUTION
!