Bullhorn SDT16 Family, Руководство по установке и настройке, Страница: 97 / 110

SDT16 Family Installation and Configuration Guide
Chapter 3. Configuration 87
Unmap a Register
Complete the following steps to unmap a register that has previously been mapped to a channel on
the Bullhorn unit:
1.
On the main configuration window, click the channel number you want to unmap. For
example, click
Channel 1
(Figure 3-27). You can also display a channel configuration
window by clicking
Tools
>
Settings
>
Channels
. When the window displays, click
Next
Register
to display the channel number you want to configure.
Figure 3-27. Unmap a Register
2.
Click
Unmap
to unmap the register and close the configuration window. When you open
the channel configuration window again,
Not Mapped
displays near the top of the window
to indicate the channel is not mapped to a register.
3.
Save all configuration settings in the event log by clicking
File
>
Save Current Setup in
Event Log
.
N
OTE
:
For more information about the Event Log, refer to Save Configuration Settings in the
Event Log on page 88 and Event Log on page 66.
4.
When you finish configuring the Bullhorn unit, continue with Transmit a Test Packet on
page 88.