Bullhorn SDT16 Family, Руководство по установке и настройке, Страница: 89 / 110

SDT16 Family Installation and Configuration Guide
Chapter 3. Configuration 79
Depending on the type of input device connected to the Bullhorn unit, map the registers using the
instructions in the following sections:

Modbus ASCII or RTU:
If you are working with a Modbus ASCII or RTU input device,
continue with the next section Map Registers for a Modbus ASCII or RTU Input Device .

Reynolds 16 or 32-Bit:
If you are working with a Reynolds 16 or 32-bit input device,
continue with Map Registers for a Reynolds 16 or 32-Bit Input Device on page 81.

Mercury:
If you are working with a Mercury input device, continue with Map Registers for a
Mercury Input Device on page 83.

Dresser:
If you are working with a Dresser input device, continue with Map Registers for a
Dresser Input Device on page 85.
Map Registers for a Modbus ASCII or RTU Input Device
Complete the following steps:
1.
On the main configuration window, click the channel number you want to configure. For
example, click
Channel 1
to display a window (Figure 3-22). You can also display a channel
configuration window by clicking
Tools
>
Settings
>
Channels
. When the window
displays, click
Next Register
to display the channel number you want to configure.
N
OTE
:
If you are mapping a 12-digit register, make sure to choose an odd-numbered
channel on the main configuration window. For more information, refer to Configure
Channels on page 78.
Figure 3-22. Modbus ASCII or RTU Configuration
2.
Type the unit address assigned to the input device in the
Unit Address
field. Valid entries
are any number from 1 to 255.