TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our toll-free
Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007.
You must give the following information:
•Name
•Telephone Number with Area Code (Fax number if applicable)
•Year, Make, and Model of the vehicle
•The model number of the system you are installing
•The type of assistance you are requesting
If you give the above information you will be called back as soon as possible, usually within 10 minutes.
2
BEFORE YOU BEGIN
Congratulations, you have purchased one of the most advanced remote starter systems ever made. Your new
remote starter is a technological breakthrough utilizing the most advanced, state of the art technology
and components. It is computer controlled and manufactured in the U.S.A. The dependability and variety of
features make Bulldog Security the leader in the industry. Enjoy your new remote starter for years to
come!
This remote system is designed to start your vehicle by sending a command signal from the remote transmitter
or by programming automatic temperature or timed start. It is required that your installation is done in
a well-ventilated area. It is the responsibility of the owner to ensure that the remote system is not
used to start the vehicle in an undesired location.
It is recommended that a carbon monoxide detector be installed in the living area near a location where
the vehicle may be garaged.
Since there are many different makes and models of vehicles, look at the wiring chart on or our website,
www.bulldogsecurity.com/wires.htm.
Read this manual thoroughly before starting the installation. You must also decide if any options are
desired such as trunk release and dome light supervision. An optional relay will be needed for these
options. Please do not skip any steps.
TACH/TACHLESS OPERATION
In most cases the decision to go with tachless mode will save time during the installation. If your vehicle
is hard-starting then you should use tach mode.
MAKE SURE YOU PLACE THE WARNING STICKER UNDER THE HOOD.
PRECAUTIONS
This system is designed for vehicles with power door locks only.
This system is designed to be used
with fuel-injected, automatic transmission vehicles only.
SAFETY FIRST!
Never start your vehicle if it is indoors, if the keys are in the ignition and you’re sure the car is in
park. A periodic safety check is recommended to ensure that your system is in proper working order.
DO NOT use mechanical wiring connections, such as crimp or snap together taps. Follow instructions
below.
DO NOT disconnect the battery if the vehicle has an anti-theft-coded radio or is equipped with an airbag.
Doing so may cause a warning light to be displayed and may require a trip to the dealer to be corrected.
DO NOT leave the interior or exterior lights on for an extended period of time as it may cause battery
drain. Remove the dome light fuse from the fuse box. NOTE: Starter systems do not work well with a partially
discharged battery.
DO NOT mount the control module until all connections have been made and tested. Using wire ties or
double sided tape, MOUNT THE MODULE UNDER THE DASH. Place the warning sticker under the hood.
