NATURAL GAS SAFETY
Your Natural Gas grill is designed to operate on natural gas ONLY, at a pressure of 4” water column (W.C.) regulated at the
natural gas regulator attached at the back of the grill. Check with your gas utility for local gas pressure and with your local
municipality for building code requirements.
Check with your gas utility or with local building codes for instructions to install gas supply line, or call a licensed and
knowledgeable installer.
It is recommended that an “ON-OFF” shutoff valve be installed at the gas supply source:
-
Outdoors after gas line piping exits outside wall and before quick-disconnect or before gas line piping enters ground.
-
Indoors in the branch fuel line in an accessible location near the supply line.
Pipe sealing compound or pipe thread tape of the type resistant to the action of natural gas must be used on all male pipe
thread. Apply compound or tape to at least the first three threads when making the connection.
Disconnect your gas grill from fuel source when the gas supply is being tested at high pressures. This appliance and its
individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at
pressures in excess of 1/2 psig (3.5 kPa).
Turn off your gas grill when the gas supply is being tested at low pressures. This appliance must be isolated from the gas
supply piping system by closing its individual valve.
WARNING:
Gas valves are preset at the factory to operate on LP or natural gas. If you wish to convert, be sure to contact
your grill dealer FIRST!
PROPANE GAS SAFETY
Your Propane gas grill is designed to operate on propane gas ONLY, at a pressure regulated at 11” water column (W.C.)
when equipped with the correct propane orifices on the valves and a propane regulator on the supply line regulated at the
residential meter.
Your propane gas grill is designed to be used with a standard 20 lbs gas cylinder and must be constructed and marked in
accordance with specifications of the US Department of Transportation for Propane gas cylinders.
Always keep cylinder securely fastened in an upright position.
Never connect an unregulated propane gas cylinder to the grill.
Do not subject Propane cylinders to excessive heat.
CAUTION:
Never store a Propane gas cylinder inside a building or in the vicinity of any gas-burning appliance.
WARNING:
Gas valves are preset at the factory to operate on LP or natural gas. If you wish to convert, be sure to contact
your grill dealer FIRST!
SAFETY !
BEWARE OF SPIDERS
BBDAFETY
CAUTION: BURNER TUBES MUST BE INSPECTED AND CLEANED BEFORE FIRST USE.
Spiders and small insects occasionally spin webs or make nests in the burner tubes during warehousing and transit. These
webs
can
lead to a gas flow obstruction, which could result in a fire in and around the burner tubes. This type of fire is
known as “FLASH-BACK” and can cause serious damage to your grill and create an unsafe operating condition for the
user. Although an obstructed burner tube is not the only cause of “FLASH BACK’ it is the most common cause, and
frequent inspection and cleaning of the burner tubes is necessary.
3
Содержание Texan Lonestar 07638
Страница 17: ...ILLUSTRATED PARTS LIST 17 ...