Bull NovaScale R422-E1, Инструкция по установке и эксплуатации

Страница: 26 / 138

2-6
N
ovaS
c
ale R422-E1/R422-INF-E1 Installation and User's Guide
Installing the Server into the Rack
You should now have rails attached to both the chassis and the rack unit. The next
step is to install the server into the rack. Do this by lining up the rear of the chassis
rails with the front of the rack rails. Slide the chassis rails into the rack rails, keeping
the pressure even on both sides (you may have to depress the locking tabs when
inserting). See Figure 2-3.
When the server has been pushed completely into the rack, you should hear the
locking tabs "click". Finish by inserting and tightening the thumbscrews that hold
the front of the server to the rack.
2-5 Checking the Serverboard Setup
After you install the NovaScale R422-E1/R422-INF-E1 in the rack, you will need to
open the top cover to make sure the serverboard is properly installed and all the
connections have been made.
Accessing the Inside of the System
Release the retention screws that secure the system to the rack.
Grasp the two handles on either side and pull the system straight out until it
locks (you will hear a "click").
Remove the four screws (two on the sides and two on the top) that secure
the top cover to the chassis. Place your thumbs in the two rectangular recess-
es and push the cover away from you (toward the rear of the chassis) until it
stops. You can then lift the top cover from the chassis to gain full access to
the inside of the server (see Figure 2-4).
To remove the system from the rack completely, depress the locking tabs in
the chassis rails (push the right-side tab down and the left-side tab up) to
continue to pull the system out past the locked position.
1.
2.
3.
4.